JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.
This website requires cookies to provide all of its features. By using our website, you agree to our use of cookies.
Website terms and conditions - Please see term click here.
Free UK Delivery on orders over £150
New customer? Start Here.
(Delivery Options Available)
Plumes® Jr MOSFET Mod Limited Edition Small Signal Shredder offers a new twist on our original Plumes® Small Signal Shredder housed in a pedalboard-friendly junior sized enclosure. Like the original, this compact pedal offers tube-like overdrive with three distinct clipping voices, with a key distinction. The third clipping mode (labeled “M”) has been swapped with a new MOSFET clipping mode that produces a harmonically rich, focused overdrive with enhanced low end and a dynamic response similar to a modern high-gain tube amp.
Symmetrical clipping utilizing a pair of light-emitting diodes. This is the crunchiest setting the Plumes has to offer.
Clean boost mode. This eliminates the soft-clipping diodes altogether and leaves you with a straight-up OpAmp drive. This is perfect for pushing your clean tone out in front or driving the preamp of an already overdriven amp into tasteful breakup territory.
We’ve swapped out the asymmetrical silicon diode arrangement that was similar to what you’d find in a stock screamer, and replaced it with a MOSFET clipping mode. This produces a commanding, open, and smooth overdrive that’s rich in harmonics and delivers an overdriven bite consistent with the sound of a cranked tube amp.
PowerThis device takes a standard 9 volt DC power supply with a 2.1mm negative center barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is ripple or unclean power. Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!
