This all-discrete, MOSFET-based circuit provides nearly 30db of unadulterated clean gain boost with a minimum amount of tone colouration. Note that you can also use this as an attenuator by turning the Boost knob counterclockwise away from the noon position.

It can also be used as a powerful buffer with an input impedance of around 5 MOhms and an output of around 1 kOhm, best used after your effects chain. This device does not create distortion or overdrive on its own. However, it can be used to drive your favourite amp or pedal into singing distorted sustain. Simple, yet effective.

Top-notch components and circuit design assure that your signal arrives to its destination in a truly pure state. Black Eye is true bypass and built one at a time by human beings on the shore front of Akron, Ohio.

Switching: This device uses mechanical true bypass switching.

Power Current Draw: 10 mA This device takes a standard 9-volt DC power supply with a 2.1mm negative centre barrel. We always recommend pedal-specific, transformer-isolated wall-wart power supplies or multiple isolated-output supplies. Pedals will make extra noise if there is a ripple or unclean power.

Switching-type power supplies, daisy chains and non-pedal specific power supplies do not filter dirty power as well and let through unwanted noise. DO NOT RUN AT HIGHER VOLTAGES!

Tech Specs Input Impedance: 5 MΩ Output Impedance: <1 kΩ Warranty