Free UK Delivery on orders over £150

You have no items in your shopping cart.

CooperSonic Reamping Device

Availability: Please call

Incl. Tax: £74.95 ( £62.46 ex VAT)
Please call
Coopersonic Reamping Device

Additional Information

Manufacturer CooperSonic
Shipping Group No
What is reamping?

Reamping is where you record something (e.g. a guitar) straight to your recorder (tape, PC, DAW) through a DI box, then later on feed the signal from the recorder into an amplifier and re-record it (usually) with a microphone.

The advantages of this are that you just need a good clean take on tape, then you can change amp settings or amps, add pedals, experiment with different mics and mic positions etc later on without having to re-do the original track.

The Reamping Box matches the level and impedance of the signal coming from you desk or recorder to your amp input, so the amp effectively “sees” a regular guitar signal.

You can of course also use the Ramping Device to interface your recorder or desk with guitar pedal type effects without overloading their inputs… very useful.

How to do it?

1. Record your instrument through a good quality DI box onto your recorder. (Use two tracks if you want to record it through an amp as well)
2. Feed the playback of the DI’ed signal from your desk or recorder into the Reamping Device input socket.
3. Connect the Reamping device output to your amp, via any effects pedals if desired.
4. Set the level control for desired volume into amp – this works just like a guitar volume control.
5. Mic up the amp and record it back onto your recorder.


Couldn’t I just use something like a passive DI box in reverse?
No – a DI box is simply not designed to handle the signal levels involved, and lots of horrible distortion will result.

What’s the ground/lift switch for?
If you find you’re getting a hum when using the Reamping Device, try flipping this switch. Depending on how your system is wired up and earthed, one position may be better than the other. Try it and see…

Can I use an unbalanced input to the Reamping Device?
The input is balanced, but will accept an unbalanced signal from a desk etc, but keep the cable short. For the technically minded it’s Pin 2 hot.

Does it need a battery?
No – the Reamping Device is a passive circuit using a transformer to match the levels and impedances correctly so requires no power.


Balanced input on XLR connector
High quality audio transformer
Output level control
Ground/lift switch
Wide frequency response
Low distortion

Write Your Own Review

You're reviewing: Reamping Device

E-commerce by